wel.gif (6819 bytes)
ioiscsi indexcompany infoioiscsi productstech supportdriver/BIOS updatesDealer/Reseller Locationsmake your ordersContact IOI

Narrow SCSI Flat Cable

Connecting Internal Narrow SCSI Peripheral
Cable Part No. CB-001

IDC 50-pin Male x 3 Flat Ribbon Internal Cable
( 53 cm; F43F10F )

The CB-001 cable is for Internal Narrow SCSI connection. It allows you to connect the SCSI host adapter with two internal type Narrow SCSI peripheral. If you have more than two Narrow peripherals, you will need to change another Internal Flat Ribbon cable with enough connectors to accommodate all of your Narrow peripherals.

The following steps will guide you to connect your internal Narrow peripheral:

Step 1
Unpack and locate the 50-pin Internal Flat Ribbon Cable in the package

CB001_img1.jpg (12140 bytes)

Step 2
Plug J1 Female connector (the long of the cable) to the IDC 50-pin Internal Male connector on the SCSI Card.

CB001_img2.jpg (9206 bytes)

Note:
1. J1, J2 are with pull tab Paper and J3 with Strain Relief.

2. With the help of pull tab paper not only make it easier to pull out the cable from device but also protect the cable for longer life cycle.

Step 3
Plug the remaining connectors to your internal Narrow peripherals.

CB001_img3.jpg (16511 bytes)

Application :
This CB-001 is a 50-pin standard Internal Flat Ribbon Cable. This cable is for use with any of Narrow SCSI Host Adapter with an IDC 50-pin Internal Male connector. This 53 cm, three connector (the host adapter and two peripherals), it provides an easy solution for connecting internal SCSI peripheral.

@

cable.gif (5249 bytes)


Narrow SCSI Flat Cable

Wide Ultra SCSI Cable

External Round Cable

LVD Twist'N'Flat Cable

LVD/SE Terminator


@

@

bluebar.jpg (12437 bytes)
products | home