|
LVD TwistNFlat Cable
Connecting Internal Ultra-2 SCSI Peripheral
Cable Part No. CB-052
68-pin Male x3 & Female x1 Internal LVD TwistNFlat Cable
( 66 cm; M52M12.5M1.5F )
The CB-052 cable is for Ultra-2 LVD ( Low Voltage Differential ) or Single Ended connection. It allows you to connect the SCSI host adapter with two internal type Wide Ultra-2 SCSI peripheral and one Terminator. If you have more than two Wide Ultra-2 peripherals, you will need to obtain an CB-052 Wide Ultra-2 Expansion cable to increase enough connectors or you will need to change another Wide Ultra-2 cable with enough connectors to accommodate all of your Wide Ultra-2 peripherals.
The following steps will guide you to connect your internal Wide Ultra-2 peripheral:
Step 1
Unpack and Locate the 68-pin Internal TwistNFlat Cable in the package.
Step 2
Plug J1 Connector ( the long of the cable) to the Internal Wide Ultra-2 connector on the SCSI Card 4206 LVD.
Note:
1. J4 is 68pin female connector for LVD Terminator or cable expansion.
2. With the help of pull tab paper not only make it easier to pull out the cable fromdevice but also protect the cable for longer life cycle.
Step 3
Plug the remaining connectors to your internal Ultra-2 SCSI peripherals.
?
Application :
This CB-052 is a 68-position Wide Ultra2 TwistNFlat cable. This cable is for use with any of LVD Host Adapter with an 68-pin Internal Wide Ultra-2 Connection. Recommended for LVD SCSI higher frequency applications. The Terminator on the Cable terminates the end of the internal SCSI bus, eliminating worries about peripheral termination. This 66 cm, four-connector (the host adapter, two peripheral and one male terminator), it provides an easy solution for connecting internal SCSI peripheral.
Note:
Internal Ultra-2 LVD SCSI peripherals come from the factory all without Terminator.
|
